Try disconnecting the pin. While not connected, the driver may detect a low level on the enable input. If it does not detect a low level, connect the ENABLE pin to GND via a solder bridge.
For more information, visit our website www.ingeniotriana.com or access the 3D printing section on the link:
http://ingenio-triana.blogspot.com.es/p/impresora-3d.html]http://ingenio-triana.blogspot.com.es/p/impresora-3d.html[/url]
For more information, visit our website www.ingeniotriana.com or access the 3D printing section on the link:
http://ingenio-triana.blogspot.com.es/p/impresora-3d.html]http://ingenio-triana.blogspot.com.es/p/impresora-3d.html[/url]