Printing starts too high Prusa i3 Tarantula autolevelsensor

Before printing starts height is ok. This happens in gcode. What i need to do to get this right? I included my config.h if it helps. I can't figure this one out. I'm using simplify 3D as software.

SENT: M105
SENT: G28
SENT: G29
SENT: G92 E0
SENT: G1 E-0.1000 F1800
SENT: G1 Z8.270 F1000
SENT: T0
RECEIVED: ok T:228.6 /225.0 B:99.5 /100.0 T0:228.6 /225.0 @:0 B@:127
RECEIVED: ok
SENT: M105
RECEIVED: Bed x: -10.00 y: -10.00 z: -10.00
RECEIVED: Bed x: 82.00 y: -10.00 z: -10.00
RECEIVED: Bed x: 174.00 y: -10.00 z: -10.00
RECEIVED: Bed x: 175.00 y: 70.00 z: -9.99
RECEIVED: Bed x: 83.00 y: 70.00 z: -9.99
RECEIVED: Bed x: -9.00 y: 70.00 z: -9.99
RECEIVED: Bed x: -10.00 y: 150.00 z: -9.99